Contractor Hub
Technical Resources for Touchless Faucet Systems
Real links for BIM/Revit, CSI specs, installation & commissioning, telemetry, and certifications — tuned for airports, offices, transit hubs, and stadiums.
Training Videos
Short demos for installation & operation (replace with your project videos anytime).
Sensor Faucet
VIDEO
Finish Options
VIDEO
Wall-Mounted
VIDEO
Installation Essentials
Hydraulics
0.35–0.5 gpm laminar; 60–80 psi regulation; hot recirculation where applicable.
Mixing & Safety
Anti-scald via ASSE 1070/ASME A112.1070/CSA B125.70; ≤120°F (49°C) outlet.
Filtration
Y-strainer 200 μm (feeds); inline soap filter 80–100 μm (multifeed).
Electrical
100–240 VAC primary; battery failover ≥ 400k activations; optional low-voltage/PoE raceways.
Durability
Electronics IP65+; IK10 plates; locking M8/M12 connectors.
Commissioning Checklist
Response
Verify activation delay ≤ 200 ms (ToF); tune dwell & shutoff.
Sanitation
Schedule purge/flush; validate thermal disinfection routines.
Integration
Enroll devices to BMS; verify telemetry tags.
Training
Create QR-linked SOP for custodial/tech teams.
Fault ≤ 0.25% / month
Water Savings ≥ 30%
BMS / Telemetry
Vendor-neutral protocols for building integration.
Tags: usage counts • fault codes • temperature • battery/AC status • soap level
Commercial touchless faucet engineering should connect sensor behavior, flow control, power architecture, basin geometry, installation tolerances, commissioning criteria, and service access within one documented specification pathway. Project teams can review architectural touchless faucet system planning , follow the fixture installation, commissioning, and handover framework , and use the complete bathroom fixture specification guide to carry technical requirements from design documentation through field verification and long-term operation.
Downloads
Support
Include project name, fixture schedule, finish codes, power/controls notes, and required certifications in your submittal email.
Field Tips
Isolation
Use isolation valves per fixture; label shutoffs clearly.
Power
Label sensor PSUs by zone; log load and circuit IDs.
Closeout
Log firmware/build numbers in closeout documentation.
