Home > Installation Instructions Alurae in Light Oil Rubbed Bronze Shower Set

BathSelect Alurae in Light Oil Rubbed Bronze Finish Shower Set

Alurae in Light Oil Rubbed Bronze Finish Shower Set Features:

Brand Name: BathSelect

Model Number: BST6109RB

Shower Head Material: Solid Brass

Finish: Oil Rubbed Bronze

Pressure balance brass valve

Mixing Valve: Water Pressure Balance Control

Standard plumbing connection-Shower Panel Unit is pre-plumbed

Minimum pressure required: 29 psi

Maximum pressure required: 72.7 psi

Ceramic Disc Technology

Double locked stainless steel shower hose 1.5m.

½" NPT Inlets and Outlets Compatible with standard US plumbing connections

Pre-set maximum temperature: 104 ºf

Automatic anti-scald device

Recommended pressure for best performance: 2 to 75 psi

Flow rate: 2.5 GPM

BathSelect® Manufacturer Warranty Information

Installation Instructions for Alurae in Light Oil Rubbed Bronze Shower Set

Before you begin, please read the installation instructions below. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you find damages, do not install.
Please note all showers must be installed by a professional and certified plumber otherwise warranty might be voided

Tangier Oil Rubbed Bronze LED Shower Set

Hand-Held Shower Instructions

5. Hole Locations For Wall Mount

Remove Front Cover (5A) from Wall Mount (5B). Use Wall Mount Screw Holes (5C) to place the desired location. Using a punch or awl, tap the screw hole locations. Holes must be vertically aligned.

7. Wall Mount Installation

Place Wall Mount (7A) into wall and inset Mounting Screws (7B) through Wall Mount Holes (7C) and tighten until Wall Mount (7A) is flush with the wall. Do Not Over Tighten! Insert Front Cover (7D) into Wall Mount (7A).

8. Drop Elbow & Hose Installation

Apply PTFE plumbers tape on both ends of Pipe Nipple (8A) (not included). Screw Pipe Nipple (8A) into the elbow inside the wall. The Pipe Nipple (8A) is to project 1/4” – 3/4” from the finished wall. Screw Drop Elbow (8B) onto Pipe Nipple (8A) and tighten until Drop Elbow (8B) is property positioned and flush to the finished wall.

Place Rubber Seal (8C) inside Hex Hose Fitting (8D). Connect Hex Hose Fitting (8D) into Drop Elbow Outlet (8E) by turning Hex Hose Fitting (8D).

9. Unit Start-Up
Turn on hot and cold water supplies, and check all connections for leaks.

10. Final Flushing

For final flushing, turn the valve on and allow water to run through the Hose (10A) for several minutes. Allow water to run for several minutes until all foreign matter clears the line.