How to Install Olivo Deck Mount Single Handle Faucet In Rose Gold Finish | BS9752
Important Note:
Before you begin, please read the installation instructions below. Observe all local building and safety codes.
Unpack and inspect the products for any shipping damages. If you find damages, do not install.
Please note all products must be installed by a professional and certified plumber otherwise warranty may be voided.
Faucet Installation Instructions
Step 1:
widespread faucet
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:(Correct way for Hose)
1. Ensure that the water supply below your sink is completely shut off by turning the valve all the way to the right. 2. Insert the spout into the prepared center mounting hole. From below, Slide one of the provided rubber gaskets onto the threaded shank, followed by the metal washer. Secure the spout to the surface using the lock nut. Tighten firmly with a basin wrench. 3. Thread the provided lock nut onto each of the mixer stems, slide one of the provided washers as well. 4. Use the provided water lines to connect the hot and cold inlets and faucet outlet. Be careful not to overtighten. 5. Connect the hot and cold pipelines to the main water supply lines. Apply plumber’s tape or thread sealant to the threads before tightening. 6. Attach the mixed water pipeline to the faucet. 7. Turn the faucet on and allow the water to flow for approximately 60 seconds. Ensure that there are no leaks and that both hot and cold water are running properly.
Flexible Connecting Hose Care must be taken when connecting the flexible connection hose from the power supply box to the spout to ensure it does not bend sharply and kink or twist. See above for recommended ways to fit the flexible connecting hose.
Important: Failure to follow these guidelines may result in poor performance and damage to the flexible connection hose.