Home > Brushed Nickel Sensor Controlled Shower Head Installation Instructions

Brushed Nickel Sensor Controlled Shower Head Installation Instructions
  • Before you begin, please read the installation instructions below. Observe all local building and safety codes.
  • Unpack and inspect the product for any shipping damages. If you find damages, do not install.
  • Please note all showers must be installed by a professional and certified plumber otherwise warranty may be voided
 shower shower Brushed Nickel Sensor Controlled Automatic Shower Head

Shower Head Installation Instructions
Tools and Materials Required
  • Adjustable Wrench
  • Plumber’s Tape
  • Dry Cloth
  • Screwdriver
  • Silicone Sealant
 shower Shower head
Step 1

Shower head 		Step 2

Shower head
Step 3

Shower head
 Step 4

Shower head
Step 5

Shower head 		Step 6

Shower head


  • Use your hands counter clockwise to unscrew the old showerhead and removed it.
  • Take out the showerhead, make sure the shower filter is placed in the connector.
  • Ensure the showerhead full horizontal alignment wall mounted shower arm thread.
  • Use your hands clockwise to tighten showerhead.
  • Insert the long end of the shower arm (2) through the flange (1) and wrap plumbers’ tape around the threaded end of the shower arm (2) in a clockwise direction, as shown. Screw the shower arm into pipe elbow inside of the wall.
  • Install new shower head on shower arm. Thread the ball onto the shower arm clockwise.