HOW TO INSTALL BRAVAT SOLID BRASS SQUARE SHOWER MIXER CONTROL VALVE IN BRUSHED GOLD FINISH | BST10221
Specs:
Flow pressure: min. 0.05 MPa—recommended 0.1 – 0.5 MPa Operating pressure: max. 1.0 MPa Test pressure: 1.6 MPa Flow rate at 1 bar flow pressure Basin: approx. 4 L/min Bath: approx. 7 L/min Shower: approx. 6 L/min Flow rate at 3 bar flow pressure Basin: approx. 12 L/min Bath: approx. 21 L/min Shower: approx. 18 L/min Hot water inlet temperature: max. 80 ℃ Recommended( energy saving): 60 ℃ Temperature: 5℃~45℃ If static pressure exceeds 5 bar, a pressure-reducing valve must be fitted. Avoid major pressure differences between hot and cold water supply. Shower Mixer Control Valve Installation Instructions
Step 1: | mixer | Step 2: |
| | |
| | | Step 3: | | Step 4: | | |
|
| | | Step 5: | | Step 6: | | | |
| | | Step 7: | | Step 8: | | | | | | | | |
1) Fix the shower valve into the wall with screws. Use a level to ensure that the valve is straight and level. (Important: Flush the water supply pipes to remove any dirt and debris before installing the valve body)
2) Wrap Teflon tape around the pipe thread. Connect hot and cold water supply lines and all the in-wall pipes (not included) as desired to the valve. Turn on the water supply and open the cartridge to check for leaks. Then, put on the protective cover.
3) Remove the protective cover when the wall finished wall is completed. Install escutcheon onto the shower valve and press it against the finished wall. Then, install the handle and diverter knob to the valve and tighten set screws with the Allen key and put on the indication button.
Function: Check connections for leaks and check function of fitting. Flow is diverted automatically from shower outlet to bath inlet when the fitting is closed.
| | |
| |
|