Home > Technicals Billa Rainfall Oil Rubbed Bronze Shower Head

Billa Rainfall Oil Rubbed Bronze WaterFall Rain Fall Shower Head with Single Handle Controller

The Billa Rainfall shower is made of brass, the modern waterfall/rainfall shower set is easy to install. The oil-rubbed bronze finish of this single-handled shower set makes it contemporary and lush. Use it in your bathroom with Venetian interior and it is certain to add to its beauty while promising you a snug bath. It has 2 spray modes; rainfall & waterfall showerhead. It's a great experience showering with the water falling directly overhead like rain or waterfall, offering you the luxury and relaxing shower enjoyment. Easy wall-mount installation and easy to clean the spray holes with a touch of a finger.

Billa Rainfall Oil Rubbed Bronze WaterFall Rain Fall Shower Head with Single Handle Controller Features:

  • Brand Name: BathSelect
  • Model Number: BZ-5811
  • Type: Shower Set
  • Cold/Hot Water Control Type: Single Holder Dual Control
  • Style: Classic
  • Size: 5.15-7.87 inches (131-200mm)
  • Number of Handle: Single Handle
  • Surface Treatment: Oil Rubbed Bronze
  • Valve Core Material: Ceramic
  • Surface Finish: Oil Rubbed Bronze
  • Installation Type: Wall Mount
  • Shower Head Material: Brass
  • Shower Head Size: 21.6"*9" (55*23cm)
  • Shower mixing valve: Brass
  • Flow Rate: 2.5 GPM
Billa Rainfall Oil Rubbed Bronze Water Fall Rain Fall Shower Head With Single Handle Controller
BathSelect® Manufacturer Warranty Information
Installation Instructions for Billa Rainfall Oil Rubbed Bronze Shower Head




1. Open the top cover and drill according to the marked position.
  • Mark by the position of the four holes.
  • Take care to avoid wires and pipes to prevent damage.
  • Be sure to confirm that the four holes are on the same horizontal line.

2. Two inlet fittings are connected to the pipe joint of the wall; then the nut, expansion screw, and inlet pipe are connected.

3. Reinstall the top cover.

Billa Rainfall Oil Rubbed Bronze Water Fall Rain Fall Shower Head with Single Handle Controller



  1. Install the valve body. Wrap the threaded portion of the joints in Teflon tape and connect the water inlet and outlet.
  2. Put the protective cover on the valve body and finish the shower wall.
  3. When the finished wall is complete, remove the protective cover.
  4. Install the escutcheon, and handle it. Tighten the set screw with an Allen wrench to secure.
  5. Attach the shower arm escutcheon to the shower arm. Wrap the threaded portions of the shower arm with Teflon tape and connect the arm to the shower inlet. Adjust the direction of the water flow as needed. Attach the rainfall showerhead to the shower arm.



BathSelect Ancient Round Antique Rainfall Wall ShoweBathSelect Ancient Round Antique Rainfall Wall Shower Head Installation Instructions Head Installation Instructions