Home > Installation Instructions for 24" Gold Tone Square Color Changing LED Rain Shower Head

How to Install 24" Gold Tone Square Color Changing LED Rain Shower Head | BST-765-1ORB



BathSelect Ceiling Shower Head

This 24" square gold tone LED shower head will turn your shower into one that looks exceptional. If you already have gold tone in your bath fixtures, it makes perfect sense to invest in gold tone shower head. Just turn on the fun in your shower by simply turning on the water, the LED lights will automatically light up and set the mood. They will even change colors automatically based on the water temperature. All this with no batteries, everything is self-powered by a built in dynamo that takes advantage of the water pressure to create the energy to light the bulbs.


Features: Visit Product Page
Showerhead Length24"
Showerhead Width24"
MaterialStainless Steel
FinishGold
Showerhead StyleContemporary Rain Shower
Mount MethodCeiling Mount
Connection1/2" US standard (included)
shower24 Inch Gold Square Multi Color LED Rain Shower Head

Important Note:

  • Before you begin, please read the installation instructions below. Observe all local building and safety codes.
  • Unpack and inspect the product for any shipping damages. If you find damages, do not install.
  • Please note all products must be installed by a professional and certified plumber otherwise warranty may be voided.


  • Shower Head Installation Instructions

    shower

    Step 1: Step 2:
    According to the template (B) mark the location of the mounting holes (1). Use a drill with a 6mm bit to drill mounting holes into studs or blocking.

    Install the mounting brackets (C) with the tapping screws (D1). Thread the shower bars (E) onto the mounting brackets, and the inlet hose (F) onto the water inlet.


    Step 3: Step 4:
    Attach the shower head (A) to the shower bars (E). Connect the inlet hose (F) to the showerhead.

    2 water inlets so the water disperses equally throughout the showerhead.




    Step 5:





    Additional Information:

    Specification:

    - The LED lights are powered by water flow and will be activated once the water is turned on.

    - Constructed from stainless steel for durability and reliability.

    - Finished in high quality, corrosion-resistant.

    - Not suitable for low pressure. The minimum required water pressure is 0.1 MPa (1 bar).

    - Flow rate 2.4 GPM (9 LPM).

    - The LED light will change its color by detecting water temperature:

    - 0-30 °C (32-86 °F): Blue LED
    - 30-40 °C (86-104 °F): Green LED
    - 40-50 °C (104-122 °F): Red LED
    - 50-100 °C (122-212 °F): Flashing Red LED



    BathSelect Installation Instructions